3/4" Arcade T-Molding – Cut to Length (Classic Cabinet Colors)

Ships in 1–2 weeks. Cut to length for you and shipped as one continuous piece. No seams on your cabinet.

What it's for: the plastic edge trim that runs around an arcade cabinet's side panels. Old T-molding cracks, fades, and falls off, and fresh molding in the right color is one of the cheapest ways to make a cabinet look factory-new again.

• 3/4" wide, for the standard 3/4" cabinet sides
• Classic arcade colors, including Pac-Man orange and Galaxian green
• 25 ft covers the sides of a typical upright, and 50 ft covers two cabinets or a big one

Install tips from the restoration forums

• Start at the bottom center of the side, so the seam ends up where nobody looks.
• Tap it in with a rubber mallet. A metal hammer marks the face.
• On curves and corners, snip small V-notches out of the barbed spine so the molding bends without bunching.
• Soak stiff molding in warm water for a few minutes first. It gets softer and wraps curves easier.
• Old slot packed with glue or broken barbs? Clean it out with a slot cutter or a thin blade before installing.